The mp-Multiboard2 evaluation board is the new version of the mp-Multiboard.
Easily control your whole setup from the Multiboard2: up to six BP7 or mp6 Bartels micropumps, flow sensors, pressure sensors, valves, etc. The user-friendly Multiboard Windows app makes it easy to control the parameters of each component.
It is compatible with the mp-Lowdriver, mp-Driver, mp-Highdriver and mp-Highdriver4 (see description below).
General
Take control of the Bartels environment... without a single line of code!
The Multiboard2 is designed to offer the highest versatility for Bartels micropumps and accessories. Based on a new Arduino controller, it interfaces with the following:
The mp-Multiboard2 is pre-programmed with an easy-to-use Windows application to control and monitor all these components easily. The Flow Control Regulation Software is now available to have your BP7 or mp6 micropump directly regulated by the flow sensor in your microfluidic setup.
A pump driver (sold separately) is required to control any Bartels micropump from the Multiboard2. The Multiboard2 can control up to 3 drivers at the same time: Highdriver4, Lowdriver or Highdriver (only one at a time), and Driver.
| Pump driver |
Highdriver4 |
Highdriver |
Driver |
Lowdriver |
| Dimensions without ESD coating |
38.1 x 17.78 x 6 mm |
10.16 x 25.40 x 4.9 mm |
10.5 x 20.5 x 5.2 mm |
10.16 x 25.4 x 5.2 mm |
| Power supply |
2.7 - 5.5 VDC |
2.5 - 5.5 VDC |
2.5 - 5.5 VDC |
3 - 5.5 V DC |
| Current consumption |
75 mA |
40 mA at 5 V |
30 mA at 5 V |
40 mA at 5 V |
| Pin arrangement |
DIL 28 ; horizontal 2.54 mm, vertical 6 mm |
DIL 18; horizontal 2.54 mm, vertical 7.62 mm |
DIL 14; horizontal ~2.54 mm, vertical ~7.62 mm |
DIL 18; horizontal 2.54 mm, vertical 7.62 mm |
| Amplitude range |
10 - 250 Vpp |
10 - 250 Vpp |
85 - 250 Vpp |
0 - 150 Vpp |
| Frequency range |
50 - 800 Hz |
50 - 800 Hz |
25 - 226 Hz |
8 - 2000 Hz |
| Signal form |
Sine, rectangular, trapezoid |
Sine, rectangular, trapezoid |
Rectangular |
Sine, custom |
Find more information and documentation here and in the blog article Bartels Mp-Multiboard2 and Comparison of the Mp-Drivers.
Content
1x Multiboard2 control board (without driver)
1x Cable to connect 2 BP7 or mp6 micropumps to the Multiboard2
1x USB-C cable
1x Syringe with Luer-to-Barb connector
Documentation
Click here to find all the datasheets, application notes, softwares and manuals for Bartels products.
Bartels Mp-Multiboard2 and Comparison of the Mp-Drivers
